Eclipse-combustion EGA4 User Manual download pdf (Page 21)

Instruction Manual MM850481 ed.01

7.2 Flue gas analysis

 Connect the gas probe to the analyzer as shown in chapter 7. DO NOT INSERT THE PROBE IN THE CHIMNEY.

 Switch the analyzer on pressing the [ON] key. The display will show the following page:

EcoLine 4000

Num. Serie: 1257

Versione: 1.000

GreenLine 4000

Num. Serie: 1257

Versione: 1.000

UniGas 3000+

Num. Serie: 1257

Versione: 1.000

This page changes automatically after same seconds or if you press a key as follows:

! Don t insert !

! probe in chimney !

Op.: Antonio

Bat: 5.2V (23.5°C)

Autozero: 180 sec

MEASURE

–

This page displays the following information: operator name, battery charge level, instrument internal temperature

and the seconds to end the autozero procedure.

OTE

: T

HE ANALYZER MUST DRAW CLEAN AIR FROM THE AMBIENT DURING THE AUTOZERO PROCEDURE

. O

THERWISE THE

MEASUREMENTS CANNOT BE ACCURATE.

It is possible to enter in “MENU” page (pressing [F1]) or in “MEASURE” page (pressing [F2]). See the appropriate

paragraphs for operations.

When autozero procedure finished, an intermittent sound advise the operator. Press the [ENTER] key to mute the

unit. The following page will be displayed:

! Now insert !

! probe in chimney !

--- FUEL --

Natural Gas

TAG SELECTION

ANALYS

–

This page allows the operator to change the fuel used and to select the Tag between the available.

♦ Fuel selection. Move the cursor symbol “X” on the desired row using the [S] and [T] keys. Press [ENTER] to

change the value. See instruction on paragraph 8.1.6.

♦ Tag selection. Move the cursor symbol “X” on the desired row using the [S] and [T] keys. Press [ENTER] to

change the value. A new page will be shown. The Tag name, the description and the progressive number will

be displayed. See instruction on paragraph 8.1.6. When in measuring mode, you can select another Tag

pressing the [MEMORY] key.

 Insert the probe in chimney. Stop it using the retaining cone and adjust the immersion depth for a gas sampling in

the middle of the exhaust gas connection pipe.

 Press the [ANALYSIS] (F1) key to begin the measurements. The following page will be shown:

CO2 0.0 %

CO 1 ppm

NO 1 ppm

Tf Tc Error

Eff --------

–

GRAPHIC

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

Comments to this Manuals

No comments

Eclipse-combustion EGA4 User Manual Page 21

Comments to this Manuals