Eclipse-combustion EGA4 User Manual download pdf (Page 26)

Instruction Manual MM850481 ed.01

7.8 Analysis data print

An internal impact printer can be installed as an option in the instrument. Read paragraph 8.10 for header report

changing.

To print the report (ticket) of the analysis use the following procedure:

 Before make all measurements you need: Smoke index, pressure and draught, T. flow, etc. After make the gas

analysis measurements and wait same seconds for measurement stabilizing. Press the [PRINT] key. The following

page will be displayed:

MEASURE HOLD

PRESS [PRINT]

NO. COPY 1

MODEL Standard

ESCAPE

–

FEED

 Use the [S] and [T] keys to move the cursor symbol to “NO. copy” or “Model” field.

 Press the [ENTER] key to change the number of the reports you have to print and/or the print model for the report.

 Press the [PRINT] key again to print the report. You can abort the printing in progress by pressing the [ESCAPE]

key.

 Press [ESCAPE] (F1) to abort the operation.

 Press [FEED] for paper advance. You can stop the paper advance by pressing the [ESCAPE] key.

7.8.1 Paper and Ribbon change

Open the cover pressing as in figure.

Extract the exhausted paper roll. You can use standard paper roll but you have to check before for its dimensions (max.

57mm ±1mm large and 48mm ±1mm roll diameter).

If necessary substitute the ribbon cartridge.

Approach the end of the new paper roll to the slot under the printer.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

No comments

Eclipse-combustion EGA4 User Manual Page 26